(e) Part 5 covers examination and testing methods and techniques. (d) Part 4 covers repairs using nonmetallic means, such as nonmetallic liners and wraps, and bonding (e.g., joining by epoxy), including bonding of metallic components. (c) Part 3 covers mechanical repairs, with or without sealant, such as bolted clamps or fixtures and includes all repair methods not covered in Part 2 or Part 4.
(b) Part 2 covers repair methods and techniques that include the use of welding, brazing, soldering, or other methods involving metal deposit. (a) Part 1 covers the scope, organization, and intent and is applicable to all articles in this Standard. This Standard is divided into five Parts. Only technical procedures and information are provided administrative or policy requirements are outside of the scope of this Standard.
#Asme y14.5 2018 full version
click here to purchase the full version from the ansi store. It is the responsibility of the user of this Standard to establish appropriate safety and health practices, and determinethe applicability of regulatory limitations prior to use. Asme y14.5 2018 (revision of asme y14.5 2009) dimensioning and tolerancing engineering product definition and related documentation practices an international standard x this is a preview of 'asme y14.5 2018'. This Standard does not purport to address all of the safety concerns, if any, associated with its use. new definitions fundamental rules modifiers dof constrained by primary datum mathematically defined datum feature contoured datum feature at rmb constraining a rotational dof contoured datum feature at mmb constraining a rotational dof offset planar datum feature at rmb constraining a rotational dof offset.
The layout of Standard has also been revised with all sections being renumbered. asme y14.5-2009 (revision of asme y14.5m-1994. These inspection and flaw evaluation methods are not covered in this Standard, but are covered in other post-construction codes and standards. This 12-hour class will highlight the changes in the updated Standard, including new symbols. One case involves coaxial same-sized holes, and the other involves multiple co-planar faces divided by grooves. The standards specify two use cases shown in the figures below.
The methods provided in this Standard address the repair of components when repair is deemed necessary based on appropriate inspection and flaw assessment. Recently, some users have been asking about whether SOLIDWORKS MBD complies with the continuous feature requirements for ASME Y14.5-2009 standards. These repair methods include relevant design, fabrication, examination, and testing practices and may be temporary or permanent, depending on the circumstances. This Standard provides methods for repair of equipment, piping, pipelines, and associated ancillary equipment within the scope of ASME Pressure Technology Codes and Standards after they have been placed in service.
0 kommentar(er)
